The IRMA Community
Newsletters
Research IRM
Click a keyword to search titles using our InfoSci-OnDemand powered search:
|
Optimizing the Performance of Plastic Injection Molding Using Weighted Additive Model in Goal Programming
Abstract
Injection molding process is increasingly more significant in today’s plastic production industries because it provides high-quality product, short product cycles, and light weight. This research optimizes the performance of this process with three main quality responses: defect count, cycle time, and spoon weight, using the weighted additive goal programming model. The three quality responses and process factors are described by appropriate membership functions. The Taguchi’s orthogonal array is then utilized to provide experimental layout. A linear optimization based on the weighted additive model in goal programming model is built to minimize the deviations of the product/process targets from their corresponding imprecise fuzzy values specified by the process engineer’s preferences. The results show that the average defect count is reduced from an average of 0.75 to 0.16. Moreover, the average cycle time becomes 13.06 seconds, which is significantly smaller than that obtained at initial factor settings (= 15.10 seconds). Finally, the average spoon weight is exactly on its target value of 2.0 gm.
Related Content
|
Frederic Andres.
© 2027.
14 pages.
|
|
Kalsoom Safdar, Khairul Najmy Abdul Rani, Mohd Aminudin Jamlos, Siti Julia Rosli, Muhammad Usman Younus, Zanab Safdar.
© 2027.
27 pages.
|
|
Bani Adam, Binastya Anggara Sekti, Muhammad Adi Zacky Zahran.
© 2027.
24 pages.
|
|
Swetha Margaret T. A., Renuka Devi D..
© 2027.
31 pages.
|
|
Maurice Saluschke, Michael Schulz.
© 2027.
30 pages.
|
|
Mirjam Sepesy Maučec, Gregor Donaj.
© 2027.
16 pages.
|
|
Jorge A. Ruiz-Vanoye, Ocotlan Diaz-Parra, Ricardo A. Barrera-Cámara, Alejandro Fuentes-Penna, Francisco R. Trejo-Macotela, Jaime Aguilar-Ortiz, Eric Simancas-Acevedo.
© 2027.
21 pages.
|
|
|