IRMA-International.org: Creator of Knowledge
Information Resources Management Association
Advancing the Concepts & Practices of Information Resources Management in Modern Organizations

Effects of Different Parameters on Delamination Factor of Glass Fiber Reinforced Plastic (GFRP)

Effects of Different Parameters on Delamination Factor of Glass Fiber Reinforced Plastic (GFRP)
View Sample PDF
Author(s): Vikas Sharma (Department of Mechanical Engineering, Haryana Institute of Engineering and Technology, Bahdurgarh, India), Vinod Kumar (Mechanical Engineering Department, Thapar University, Patiala, Punjab, India)and Harmesh Kumar (Department of Mechanical Engineering, UIET, Panjab University, Chandigarh, Punjab, India)
Copyright: 2013
Volume: 3
Issue: 2
Pages: 15
Source title: International Journal of Manufacturing, Materials, and Mechanical Engineering (IJMMME)
Editor(s)-in-Chief: J. Paulo Davim (University of Aveiro, Portugal)
DOI: 10.4018/ijmmme.2013040102

Purchase

View Effects of Different Parameters on Delamination Factor of Glass Fiber Reinforced Plastic (GFRP) on the publisher's website for pricing and purchasing information.

Abstract

The experimental investigations of the delamination factor of glass fiber reinforced plastic at different cutting parameters are reported in this study. This paper has involved the determination of different factors affecting the hole quality and cause of delamination in a glass fiber reinforced plastic. The various process parameters like different twist drill bits of different materails, different point angle at different speed, feed rate have been taken. The thrust forces and torque values were measured using piezoelectric dynamometer. Mathematical model has been developed for different machining conditions using Minitab software with help of Taguchi design to plan the experiments. The Universal microscope has been used which determines delaminated diameter in GFRP specimens. The finite element method has been applied by using Ansys11.0 software which helped to find out delaminated diameter. It was experimentally observed that for the tungsten carbide and M50 drill bits, the thrust force and torque significant increases on increasing the point angle and feed rate.

Related Content

Meng-Ting Chiang, Pei-Ing Lee, Ang-Ying Lin, Tung-Han Chuang. © 2024. 11 pages.
Jean Claude Mallia, Anthea Agius Anastasi, Sophie Marie Briffa. © 2023. 20 pages.
Manik Barman, Tapan Kumar Barman, Prasanta Sahoo. © 2022. 26 pages.
Vinod Kumar V. Meti, G. U. Raju, I. G. Siddhalingeshwar, Vinayak Neelakanth Gaitonde. © 2022. 13 pages.
Sandeep Kumar Khatkar, Rajeev Verma, Suman Kant, Narendra Mohan Suri. © 2022. 19 pages.
Jason van Dyke, Michel Nganbe. © 2022. 19 pages.
Basant Lal, Abhijit Dey, Mohamamd Farooq Wani. © 2022. 12 pages.
Body Bottom